Cisco Network Device 2800 Introduction Manual page 118

Installing and Removing Filler Panels in Network Module Slots
Figure 8
1
2
Installing Filler Panels in Network Module Slots
A network module slot must be empty before you install a filler panel.
Note
Install filler panels as follows:
Step 1 Orient the filler panel for insertion, with the captive retention screw at the right side.
Insert the filler panel into the far right edge of the slot.
Step 2
Guide the inner end of the filler panel into the square hole at the rear of the network module slot, and
Step 3
align the retention screw with the threaded screw hole in the chassis, slot divider, or adjacent filler panel.
Note
Tighten the retention screw.
Step 4
Removing Filler Panels from Network Module Slots
A network module slot must be empty before you remove a filler panel.
Note
To remove a filler panel, loosen the captive retention screw and pull the filler panel straight out of the
slot.
Installing Network Modules in Cisco 2800 Series Routers
6
Filler Panels for NME and NM
S
L
O
T
X
A= FD 3
NK A
A= LI
T
A= AC 0/ 0
EE D G E
F
S= SP
0/ 1 S
G E S
L
O
A L
T
1
F
0
S AI M
M 1
0 AI
L
PV DM
DM 1
2 PV
PV DM
Filler panel
Slot divider
You may be securing the filler panel to the router chassis, to another filler panel, or to a slot
divider, depending on its installation location.
S
L
O
T
2
S
L
O
T
0
3
2
1
3
Blank panel
4
Filler panel
T
D
M
0
4
OL-5790-01