System Messages - Cisco Network Device 2800 Introduction Manual

Table 2 LED Indicators on Cisco 2800 Series Routers (continued)
LED Indicator State
S = Speed 1 blink + pause
(Off (Cisco 2801
router))
2 blinks + pause
(On (Cisco 2801
router))
3 blinks + pause
L = Link Off
Green
PVDM0 Off
PVDM1
Green
2
PVDM2
(Packet voice data
Amber
modules)
AIM0 Off
AIM1
Green
(Advanced integration
modules)
Amber
1. The 3 blinks+pause state is applicable to the Cisco 2821 and Cisco 2851 routers only. The Cisco 2801 and Cisco 2811 do not have 1000 Mbps ethernet
ports.
2. The PVDM2 LED is applicable only to the Cisco 2821 and Cisco 2851 routers.

System Messages

This section describes system error and recovery messages that may appear when a Cisco 2800 series
router is operated. Cisco IOS software displays system error and recovery messages on an external
device console terminal screen. (For more information, see the
Modem" section on page
OL-5789-01
Meaning
Ethernet port next to the LED
is operating at 10 Mbps.
Ethernet port next to the LED
is operating at 100 Mbps.
1
Ethernet port next to the LED
is operating at 1000 Mbps.
Ethernet link is not
established.
Ethernet link is established.
No PVDM installed in slot
(0, 1, 2).
PVDM in slot (0, 1, 2) is
initialized.
During bootup—PVDM in
slot (0, 1, 2) is detected.
After bootup—PVDM in slot
(0, 1, 2) failed to initialize.
No AIM installed in slot
(0, 1).
AIM in slot (0, 1) is
initialized.
AIM in slot (0, 1) failed to
initialize.
12.)
Corrective Action
Indication is for information only.
Indication is for information only.
Indication is for information only.
Ethernet not active or not connected. Check
Ethernet connections
Router not configured properly. Check
configuration and make corrections as necessary.
Normal indication. No action required.
Indication is for information only.
Normal indication. No action required.
If PVDM fails to initialize, replace the PVDM. To
replace the PVDM, refer to the
Removing PVDMs" section of the
Upgrading Internal Modules in Cisco 2800 Series
Routers" online document.
Indication is for information only.
Normal indication. No action required.
Replace the AIM. To replace the AIM, refer to the
"Installing and Removing AIMs"
"Installing and Upgrading Internal Modules in
Cisco 2800 Series Routers" online document.
"Connecting to a Console Terminal or
Troubleshooting Cisco 2800 Series Routers
System Messages
"Installing and
"Installing and
section of the
7