Cisco Network Device 2800 Introduction Manual page 161

Figure 32
1
2
Step 6 Insert the screws that fasten the ILP supply to the chassis.
Step 7 Connect the main power supply cable to the main power supply connector, and connect the ILP supply
cable to the ILP supply connector.
Step 8 Verify that the vent blocking plate has been removed in Step 4. The ILP fans should be visible through
the vents that were blocked by the vent blocking plate.
Installing a Power Supply in a Cisco 2811 Router
Three types of power supplies are available for the Cisco 2811 router:
•
•
•
The following sections describe how to install each type of power supply.
•
•
•
•
OL-5792-04
Inserting the ILP Supply into the Cisco 2801 Router
4
3
ILP supply fastening screws
ILP supply
An AC-input power supply, driven by external AC power
A DC-input power supply, driven by external DC power
An inline power (ILP) supply, driven by external AC power. This supply provides power for the
router and inline power for a complement of IP phones attached to the router.
Removing the Existing Power Supply, page 34
Installing an AC-Input Power Supply, page 36
Installing a DC-Input Power Supply, page 38
Installing an ILP Supply, page 40
1
3
ILP connector
4 Main power connector
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
Replacing the Power Supply
2
33