Cisco Network Device 2800 Introduction Manual page 124

Installing and Removing Slot Dividers
Figure 3
Install slot dividers into HWIC slots on Cisco 2811, Cisco 2821, and Cisco 2851 routers as follows:
Guide the two halves of the slot divider between the two rails in the bottom of the HWIC slot. See
Step 1
Figure 4.
Figure 4
Push the slot divider in until it seats and locks into place. When the slot divider is fully seated, its outer
Step 2
end is flush with the front panel of the router. See
Gently pull the slot divider to check for complete seating. If properly seated, it does not come out.
Step 3
Installing Interface Cards in Cisco 2800 Series Routers
4
Slot Divider for HWIC Slots on Cisco 2811, Cisco 2821, and Cisco 2851 Routers
Inserting Slot Divider into an HWIC Slot on Cisco 2811, Cisco 2821, and Cisco 2851 Routers
Figure 5.
OL-5791-01