OPERATING CONTROLS AND PROCEDURES
12V Receptacle . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
(If Equipped) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
CONTROLS AND INDICATORS
The engine is electronically controlled by the Electronic
Control Module (ECM); it is the control center of the entire
engine system. The ECM processes all of the inputs and
sends commands to the fuel systems as well as vehicle and
engine control devices. This Operator Manual does not
include information on the engine ECM, however a separate
manual as prepared in detail by the engine manufactured is
shipped with the crane at the factory.
All the controls and indicators to operate and monitor crane
functions are found inside the crane cab Figure 3-2 and
include the following:
1.
Foot Pedals
2.
Outrigger Control
3.
Seat Joystick and Armrest Controls
4.
Side Display Panel
5.
Steering Column
6.
Overhead Control Panels
3-2
Fuse Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-18
Buzzer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-18
Cranes) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-19
(Optional) (Not Shown) . . . . . . . . . . . . . . . . . . . . 3-19
Emergency Exit . . . . . . . . . . . . . . . . . . . . . . . . . . 3-20
7649-5
STEERING COLUMN
The steering column assembly in Figure 3-2 is a pedestal
style tilt and telescoping steering column. It has the ability to
tilt forward 30° or be raised vertically approximately 60 mm
(2.5 in). It also includes the ignition switch and the CANbus
gauge display (11) (Figure 3-2).
Published 9-04-2014, Control # 364-10
RT765E-2 OPERATOR MANUAL
6
5
4
2
3
1
FIGURE 3-1
Need help?
Do you have a question about the Grove RT765E-2 and is the answer not in the manual?
Questions and answers