Section 5; Environmental Protection; Lubricants And Lubrication Intervals - Manitowoc Grove RT765E-2 Operator's Manual

RT765E-2 OPERATOR MANUAL
SECTION CONTENTS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1

Environmental Protection . . . . . . . . . . . . . . . . . . . 5-1

Lubrication Intervals . . . . . . . . . . . . . . . . . . . . . . . 5-1
Standard Lubricants. . . . . . . . . . . . . . . . . . . . . . . . 5-2
Arctic Lubricants and Conditions . . . . . . . . . . . . . 5-3

Lubricants and Lubrication Intervals . . . . . . . . . . 5-5

Standard Lubricants . . . . . . . . . . . . . . . . . . . . . . . 5-6
Arctic Lubricants and Conditions . . . . . . . . . . . . . 5-7
Surface Protection for Cylinder Rods . . . . . . . . . 5-10
Wire Rope Lubrication . . . . . . . . . . . . . . . . . . . . . 5-10
Lubrication Points . . . . . . . . . . . . . . . . . . . . . . . . 5-10
CraneLUBE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-10
GENERAL
Following the designated lubrication procedures is important
in ensuring maximum crane lifetime and utilization. The
procedures and lubrication charts in this section include
information on the types of lubricants used, the location of
the lubrication points, the frequency of lubrication, and other
information.
ENVIRONMENTAL PROTECTION
Dispose of waste properly! Improperly disposing of waste
can threaten the environment.
Potentially harmful waste used in Manitowoc cranes includes
- but is not limited to - oil, fuel, grease, coolant, air
conditioning refrigerant, filters, batteries, and cloths which
have come into contact with these environmentally harmful
substances.
Handle and dispose of waste according to local, state, and
federal environmental regulations.
When filling and draining crane components, observe the
following:
• Do not pour waste fluids onto the ground, down any
drain, or into any source of water.
• Always drain waste fluids into leak proof containers that
are clearly marked with what they contain.
Grove

SECTION 5

LUBRICATION
Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-10
Steering and Suspension. . . . . . . . . . . . . . . . . . . 5-11
Axles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-13
Drive Train . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-15
Drive Train (continued) . . . . . . . . . . . . . . . . . . . . 5-17
Turntable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-19
Outriggers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-21
Boom . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-23
Boom (continued) . . . . . . . . . . . . . . . . . . . . . . . . 5-25
Boom (continued) . . . . . . . . . . . . . . . . . . . . . . . . 5-27
Hoist. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-29
Hydraulic . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-31
• Always fill or add fluids with a funnel or a filling pump.
• Immediately clean up any spills.
LUBRICANTS AND LUBRICATION
INTERVALS
The service intervals specified are for normal operation
where moderate ambient temperature, humidity, and
atmospheric conditions prevail. In areas of extreme
conditions, the service periods and lubrication specifications
should be altered to meet existing conditions.
NOTE:
Chassis grease lubricants must not be applied with air
pressure devices as this lubricant is used on sealed
fittings.
The multipurpose grease applied during manufacturing is
of a lithium base. Use of a non-compatible grease could
result in damage to equipment.
Published 9-04-2014, Control # 364-10
All fluids and lubricants may be purchased by
contacting an authorized Manitowoc distributor or
Manitowoc Crane Care Parts Department.
CAUTION
Possible Equipment Damage!
LUBRICATION
5
5-1