Tele System TS ULTRA 4K User Manual page 44

TELE System
6.2 Multimedia player
Before proceeding to the use of a USB type of mass storage such as a disk-drive (Hard Disk Driver - HDD) or a flash
memory/flash drive, follow the relevant rules and warnings in paragraph 6.1.
The Multimedia Player function, commonly called Media Player, plays MPEG-2 / MPEG-4 video content, MP3 music and
displays JPEG photos from external memory connected via a USB interface.
After the receiver has detected the USB memory device, enter the menu Multimedia > Go to Media Play List, select the
desired folder, then press OK on the media to read.
NOTES

We cannot guarantee compatibility with all USB storage devices on the market and with all types of media and
audio/video codec files.

Video playback capability of UHD/4K contents is restricted to HEVC/H.265 video codec.
6.3 Personal Video Recorder (PVR)
Before proceeding to the use of a USB type of mass storage such as a disk-drive (Hard Disk Driver - HDD) or a flash
memory/flash drive, follow the relevant rules and warnings in paragraph 6.1 and 6.3.1.
6.3.1 Technical characteristics of the recorder
Below is a list of information and rules to consider and adhere for a correct use of the recording functions:
1. Use NTFS formatted memory in order to avoid limitations in recording file size.
2. The USB memory connected to the receiver must have a capacity greater than 50MB. Under this limit, the receiver
cease any recording in progress, including the TimeShift.
3. Minimum duration of a recording is one minute, otherwise resultant file can not be saved.
4. For recording you should always use a high-performance 3.0 USB memory device (see par. 6.1.3) connected to the
USB 3.0 port on the rear panel of the receiver, especially for UHD channels.
5. The receiver allows up to 2 simultaneous recordings.
6. While recording a channel, you can only go to another channel which is transmitted on the same frequency of the
one in recording or which is received from the other tuner (terrestrial / satellite).
7. While recording a program decrypted by the CAM, you can view and/or record simultaneously another channel
which is not decoded by the CAM.
8. Contents recorded from a scrambled channels through the CAM, saved in
playable only by the same receiver that has performed the recording.
9. Before proceeding with a recording longer than three hours, disable or properly change the Auto Power Down (see
par. 5.7).
10. Remember to keep the USB memory connected to avoid the failure of scheduled recordings.
11. If a scheduled timer has to start while another recording is already in progress and both of these events are in
conflict (e.g. because they do not comply with a rule of the above points 5, 6 and 7), a message on screen will ask the
user to choose the recording to end in favor of the other one. If user selection is not done, after a few seconds the
timer will fail in favor of the current recording.
NOTE
Broadcasters may decide to ban recording for issues related to the protection of copyright.
6.3.2 Recorder configuration
Once the USB memory is connected and recognized, enter the menu Multimedia > PVR Setup and set the parameters
listed below:
Storage Device
1. : Selection of the USB storage device committed as recording archivie.
2. Default Record Duration
3. Timeshift Setup : Type of Timeshift (see par. 6.3.3).
4. Timeshift Duration : Duration of the Timeshift period.
6.3.3 Timeshift
Timeshift is tasked to temporarily record a TV show in two different ways (see par. 6.3.2):
1. Auto (Automatic): it starts as soon as you tune into it until you switch channels, then it will automatically switch to
temporarily record the new channel.
Manual : it starts as soon as the 2d (PLAY/PAUSE) button is pushed and stops by pressing 3 (STOP) or changing
2.
channel.
During Timeshift, the user can pause and then resume watching the time-shifted program. Next, use the 3 (STOP)
button to return toa live viewing.
16
: Duration of a manual recording.
RecordedFiles Scrambled
/ folder, are