Tele System TS ULTRA 4K User Manual page 36

TELE System
LNB Power
3. : For the possible disabling LNB power supply, useful in case of IF-IF type systems.
NOTE
The Level Indicators and Signal Quality refer to the first default transponder for the selected satellite.
Do not enable the DiSEqC 1.0 / 1.1 parameters, then press OK on
WARNINGS

The wrong antenna configuration can result in failure to laod some or all channels. If you do not know the
characteristics of your antenna system and/or you are unable to properly configure the receiver yourself, you may
want to contact a professional installer for advice.

The satellite relative to TivùSat channels is HotBird 13° East, also corresponding to the classical orbital position
used for the majority of Italian channels.
Step 6. Antenna Setting (DTT)
This step is displayed if you have previously opted for the terrestrial antenna. Then set the following parameters:
1. Region : The country where the receiver is intalled.
2. Antenna 5V : Antenna supply 5V
the coaxial cable connected to the antenna input of the IN RF receiver.
WARNINGS

The wrong antenna configuration can result in failure to laod some or all channels. If you do not know the
characteristics of your antenna system and/or you are unable to properly configure the receiver yourself, you may
want to contact a professional installer for advice.

If you are using a classical roof antenna or an independently powered one, the power antenna must be set to off: risk
of overloading!
Press OK on Next to continue.
Step 7. Search Channels / Terrestrial LCN Conflicts / Result
At this point the receiver will perform an auto-scan of satellite and/or terrestrial channels (depending on the type of
antenna chosen in Step 4); this will take several minutes.
At the end of the channel search, if the
require the same position, the receiver will ask you to express your preferences in order to preset the selected channel.
At the end, the screen will show you the result of the installation. Press OK on
Channel viewing
Once the installation is finished, you may immediately view the loaded channels. To change channel, proceed in one of
the following ways:

Press the DTT/SAT button to change the viewing between viewing terrestrial channel viewing to the satellite ones.

Press the PROG+/PROG- buttons or the arrows ▲/▼ on the front pannel to go respectively to the following or the
previous channel.

Digit the number of the desired channel by using the numeric buttons 0÷9 on the remote control.

Press the OK/LIST button on the remote control to access the channel list, scroll down each single channel using
the arrow keys ▲/▼ or by the page with the buttons ◄/►, use the RED and GREEN colored keys to go to the list,
respectively Terrestrial or Satellite channels, and then confirm the desired channel with the OK button.
We also suggest that you read all the contents of this user manual. In particular, we highlist Chapter 4 on the basic use
of the receiver and Chapter 5 for the main settings such as audio/video settings (paragraph 5.8) and many others.
8
(100mA Max), to be activated if you are using an active antenna to feed through
Terrestrial LCN
function is active (see previous Step 4) and multiple channels
Next to continue.
Finish
to go directly to viewing channels.