Tele System TS ULTRA 4K User Manual page 29

1 Safety and disposal standards
For safe use of this appliance and your own safety, please read these instructions on safety measures.
POWER SUPPLY

The receiver must be connected to a 230V ~ 50Hz power outlet via the supplied external power cord.

Do not remove the receiver cover. Voltages greater than the power supply may be present inside the unit that could
jeopardize your safety. High voltage is present even when the device is in standby mode so before working on it, you
must unplug it from the power supply.
immediately !
POWER CORD

Before installing the appliance,check the integrity of the power cable, paying particular attention to the point where
it enters the wall outlet and where it exits the receiver. If the power cable is damaged, do not connect the device and
contact the service center

Install the powercable so as not to cause crushing of items placed above or next to it. Also, do not place it near the
area where it could be accidentally trampled on, torn or otherwise damaged

If the cable is damaged, carefully disconnect the receiver from the power outlet and contact only qualified personnel
or the service center for repair
LIQUIDS

Keep the product away from any kind of liquid. Do not place objects filled with fluids such as vases, humidifiers and
so on the device which should not be installed in places where it may come in contact with sprays or drops of water
or in environments with high humidity where condensation may occur.

In the event that the receiver is accidentally in contact with liquid, immediately remove the plug from the socket. Do
not touch the device with your hands before it has been disconnected
SMALL ITEMS

Keep needles or other small items away from the receiver.Objects that fall within the device, through the slits or air
vents, may cause serious damage
CLEANING

Prior to cleaning, disconnect the device from the power outlet

To clean the outside of the receiver, use a soft,dry, or slightly moistened cloth. Avoid using chemicals or solvents
VENTILATION

Wherever the device is installed, make sure there is good air circulation to ensure sufficient heat dissipation and to
avoid overheating .

It is appropriate to provide a minimum distance of 10cm from both sides and a distance of 15 cm above the device in
order to allow proper ventilation

The air vents must be kept clear from any obstructions such as newspapers, tablecloths, upholstery fabrics, etc.

Avoid placing the receiver near heat sources (radiators, stoves, etc.) or on top of other heat-producing equipment
(VCRs, audio amplifiers, etc.)
ATTENTION!

Keep the product out of the reach of children.

The packaging plastic bags can be dangerous. To avoid suffocation keep the bags out of the reach of children.

Do not expose the receiver or the remote control to direct sunlight, fire, or fire risks

The appliance must be placed on a solid, secure base

Connect the receiver to AC power only after you have completed the necessary installation connections

A proper disposal of the appliance enables you to avoid potential damage to the environment and human health, as
well as to facilitate recycling of components and materials contained in it. Do not disperse in the environment. Those
who disperse the device in the environment or trow it away with community waste is liable to be punished according
to local legislation.

The manufacturer provides a system for recovery (RAEE or REEE) of the product which is collected
separately and provides treatment systems using equipment in accordance with current provisions.

Take the unusable product (and any accessories, including the battery) to a recycling center authorized
to handle electrical and electronic equipment waste, as it cannot be combined with other waste.
Alternatively you can return the used or obsolete device to the distributor while replacing it with a new
equivalent product.
Unauthorized removal of the cover will invalidate the guarantee
.
.
.
.
.
.
.
.
.
.
TS ULTRA 4K
.
.
1