BAFANG MAX Drive System Dealer's Manual page 50

6.5.2 Setting preparation
When the display is active, press
< 0.3 seconds). the system will enter the MEnu pa-
rameter setting state, in which the display parameters
can be set. Press twice again (interval < 0.3
seconds) to return to the main menu.
Menu for entering the parameter settings
In the parameter setting state, when the parameter you
want to set begins to flash, press
parameter value. Briefly press
the parameters to be set. Press
< 0.3 seconds) to exit the submenu.
If no operation is performed for 10 seconds, the display
will return to the normal riding display.
49
6.5.3
twice (interval Press
enters the MEnu state. In the speed field tC is dis-
played. If you press
temporary data, e.g. maximum speed (MAXS), average
speed (AVG) and single-trip distance (tRIP) can be
cleared. Briefly press
km/mile setting interface.
If the user does not reset the data, the single trip
distance and the accumulated total riding time will
be automatically cleared when the accumulated total
riding time exceeds 99 hours and 59 minutes.
/ to adjust the
to switch between
twice (interval
The data will not be cleared when the display's light-
sensing function is set to 0 or when it is switched off.
6.5.4
When the speed field displays S7, press
switch between km/h and mph, or to set km or mile.
After this setting, briefly press
enter the setting interface of light sensitivity.
DEALER MAnuAL Max Drive SySteM
Data reset
twice (interval < 0.3 seconds) – the display
, a y is also displayed. now all
(< 0.3 seconds) to enter the
km/mile
(< 0.3 seconds) to
/ to