Smart Cover Sensor - HP xw4000 Service & Reference Manual

8.2.2 Smart Cover Sensor

The Smart Cover Sensor is a software-controllable feature standard on hp workstation xw4000
and hp workstation xw6000 systems. This sensor can be activated with the Setup utility to detect
access panel removal and can be used as a security or maintenance aid. The sensor switch is
located on a mounting bracket toward the front of the chassis next to the drive bay area.
To remove the sensor switch use the following procedure:
1. Prepare the computer for disassembly.
2. Remove the access panel.
3. Disconnect the sensor switch cable 1 from the system board.
4. Push the sensor switch toward the front of the chassis 2 and then remove it downward from
the mounting bracket 3.
Installation is the reverse of removal.
Service Reference Guide
Removal and Replacement Procedures Security Components
8–3