Using Computer Setup Utilities - HP xw4000 Service & Reference Manual

2.1.1 Using Computer Setup Utilities

To access the Computer Setup Utilities (F10) menu, complete the following steps:
1. Turn on or restart the computer. To restart the computer in Windows click Start > Shut
Down > Restart the Computer.
2. When the F10 Setup message appears in the lower-right corner of the screen, press the
key. Press Enter to bypass the title screen, if necessary (for English only).
If you do not press the
then on again, to access the utility.
F12
Pressing the
A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security,
Power, and Advanced. Section 2.1.2 in this chapter provides more information about the features
that are available.
3. Using the arrow keys or the Tab key, select the option you want and press Enter. To return to
the Computer Setup Utilities menu, press Esc.
4. To apply and save changes, select File > Save Changes and Exit.
If you selected an option that automatically restarted the computer, changes were applied
at that time.
If you have made changes that you do not want applied, select Ignore Changes and Exit.
If you have already applied changes you now want to eliminate, select Set Defaults and
Exit. This option will restore the original system defaults.
Be sure to configure new options and drivers in the operating system after they have been
configured by the Setup Utility.
Service Reference Guide
F10
key while the message is displayed, you must turn the computer off,
key initiates Network Service Boot for Remote System Installation.
Setup Utilities and Diagnostic Features
F10
2–3