Removal and Replacement Procedures
This chapter describes the procedures for removal and replacement of chassis subassemblies. For
an overview of the chassis refer to Chapter 6 "Identifying the Chassis, Routine Care, and
Disassembly Preparation."
CAUTION: When the computer is plugged into an AC power source, voltage is always applied to the
Ä
system board. You must disconnect the power cord from the power source before opening the computer
to prevent system board or component damage.
10.1 Access Panel Removal
The cooling fan is off only when the computer is turned off or the power cable has
Ä
CAUTION:
been disconnected. The cooling fan
"Suspend" modes.
1. Prepare the computer for disassembly.
2. Loosen the thumbscrews that secure the access panel to the back of the computer chassis.
Not all thumbscrews used are captive. Thumbscrew design may vary by model.
3. Slide the access panel backward approximately 1-inch (2.5-cm); then lift it up and off the
unit.
removing CMT access panel
Service Reference Guide
is always on when the computer is in the
Access Panel Models with Thumbscrews
10
Chassis
"On," "Standby," or
10–1