HP xw4000 Service & Reference Manual page 23

Heading Option
PCI Devices
Advanced Bus Options
(continued)**
Device options
PCI VGA
Configuration
*Option not supported on all products.
**These options should be used by advanced users only.
Service Reference Guide
Description (Continued)
Lists currently installed PCI devices and their IRQ settings.
Allows you to reconfigure IRQ settings for these devices or to
disable them entirely. These settings have no effect under an
APIC-based operating system.
Enables/disables PCI bus mastering, PCI VGA palette
snooping, PCI SERR# generation, and ECC on select models.
Allows you to set printer mode (EEP+ECP), Output only,
bidirectional, and NumLock state at power-on.
Enable/disable Power Management Events (PME) wakeup
events, processor cache, processor number, ACPI thermal
mode, and ACPI S3 support. (When ACPI S3 is enabled you
may also enable/disable ACPI S3 video repost, PS/2 mouse
wakeup, and hard disk reset.)
Allows you to select AGP aperture size (4, 8, 16, 32, 64, 128,
or 256 MB).
Enables monitor tracking.
Allows users to specify which VGA controller will be the "boot"
or primary VGA controller.
Appears only if there are multiple PCI video adapters in the
system.
Setup Utilities and Diagnostic Features
2–9