Remote Security Management; Remote Wakeup And Remote Shutdown; Nic Alert - HP xw4000 Service & Reference Manual

Desktop Management

3.3.7 Remote Security Management

Remote Security Management allows the system administrator to safely set or modify security
features on remote workstations directly from the centralized network management console.
Enabling the system administrator to perform these tasks remotely, on multiple computers,
results in consistent deployment of and greater control over client computer security parameters
over the network.
Your computer must be powered on, or turned on through Remote Wakeup, to take advantage of
Remote Security Management. Use of Remote Security Management also requires an established
setup password.
For more information about the Remote Management Setup software and enabling Remote
Security Management, refer to the online Remote Management Administrators Guide. The
Remote Management Administrators Guide is included with the Remote Management Setup
Utilities, and is available on the HP web site at www.hp.com.

3.3.8 Remote Wakeup and Remote Shutdown

If your computer has an optional network card installed, it may support the Remote Wakeup and
Remote Shutdown functions. These functions allow a system administrator to power on and
power off a client computer from a remote location supported by PC LAN management tools.
Third-party software tools are required to remotely distribute software.
Remote Wakeup allows the network interface controller to continue functioning when power to
the computer has been turned off, but the power cord is still connected to an electrical outlet.
The computer continues to consume a small amount of electricity even after you turn it off. Only
when you disconnect the power cord from the electrical outlet does the computer stop consuming
electricity.
To enable Remote Wakeup and Remote Shutdown, complete the following steps:
1. Double-click the Network Icon, located in the Control Panel.
2. Double-click the appropriate network controller.
3. Click the Advanced Properties tab.
4. Select Remote Wakeup.
5. Change the value to ON.
6. Click OK to save and apply changes, then click OK to exit the Network dialog.
For more information on using Remote Wakeup and Remote Shutdown, refer to the online
Remote Management Administrators Guide. The Remote Management Administrators Guide is
included with the Remote Management Setup Utilities, and is available on the HP web site at
www.hp.com.

3.3.9 NIC Alert

The NIC Alert function enables desktop PCs to send an immediate alert to the network
administrator when there is a hardware or operating system failure, or evidence of tampering. An
alert will be sent even if the system is powered off or the operating system has not yet started.
3–6 Service Reference Guide