Installing A New Drive - HP xw4000 Service & Reference Manual

6. While holding the drivelock in the unlocked position, remove the drive from the
drive bay.
7. Remove the four guide screws from the drive.
8. Install two guide screws on each side of the replacement drive.
Metric screws (M3) have a black finish; U.S. screws have a silver finish.
Replace the drive by reversing the above procedure.
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage the
Ä
internal components of the drive.
9.3

Installing a New Drive

Use the following procedure for installing a hard drive:
1. Install two guide screws on each side of the replacement drive 1.
2. Ensure that the guide screws line up with the guide slots 2, then slide the drive into the drive
bay until it snaps into place.
3. Connect the power and signal cables to the back of the drive.
4. Remove the bezel blank from the subpanel, if necessary.
5. Reinstall the subpanel and the front bezel.
Refer to the previous drawing for these steps.
Service Reference Guide
Removal and Replacement Procedures Drives
9–3