HP xw4000 Service & Reference Manual page 111

4. On hp workstation xw6000 systems use the following procedure:
a. Remove the air baffle by lifting it straight up and out.
hp workstation xw6000 (Configuration 1) air baffle removal
The xw6000 Configuration 2 does not have an air baffle to remove.
b. On the Configuration 2 system, disconnect the fansink from the system board.
c. Loosen the four captive screws 1 securing the heatsink to the chassis.
d. Remove the heatsink 2 by first twisting then lifting it off the processor.
CAUTION: The captive screws allow minimal but adequate lateral movement of the heatsink. If the bond
Ä
between the heatsink and the processor does not break with moderate twisting pressure then repeat the
warm-up procedure described previously. Never pull the heatsink straight out or damage may occur to
the processor, socket, or both.
e. Raise the handle 3 on the ZIF socket about 135
f. Remove the processor by grasping it by the edges and pulling it straight up and out of the
socket.
hp workstation xw6000 (Configuration 1) heatsink and processor components
To install a heatsink and processor refer to section 11.1.3.
Service Reference Guide
Removal and Replacement Procedures System Board with Major Components
o
.
12–5