HP xw4000 Service & Reference Manual page 20

Setup Utilities and Diagnostic Features
Heading Option
Storage Options
(continued) (continued)
DPS Self-Test
Controller Order
SCSI Narrow
Termination
Boot Order
Security Setup Password
Power-On
Password
Password
Options
Smart Cover
2–6
Description (Continued)
Diskette MBR Validation
Allows you to enable or disable strict validation of the diskette
Master Boot Record (MBR).
If you use a bootable diskette image that you know to be
valid, and it does not boot with Diskette MBR Validation
enabled, you may need to disable this option in order to use
the diskette.
Allows you to execute self-tests on IDE hard drives capable of
performing the Drive Protection System (DPS) self-tests.
This selection will only appear when at least one drive
capable of performing the IDE DPS self-tests is attached to the
system.
Allows you to specify the order of the attached hard drive
controllers. The first hard drive controller in the order will have
priority in the boot sequence and will be recognized as drive C
(if any devices are attached.
The selection will not appear if all hard drives are attached to
the embedded IDE controllers.
Allows you to configure SCSI termination on the external SCSI
connector for narrow SCSI drives. The feature should only be
enabled if using a narrow SCSI drive to terminate the external
SCSI channel.
Allows you to specify boot order of installed peripheral devices
(such as LS-120 drive, diskette drive, hard drive, SCSI drive,
CD-ROM drive, or DVD-ROM drive).
Enables setup (administrator) password.
See Section 3.4, "Asset Tracking and Security," for more
information.
Enables power-on password.
See Section 3.4, "Asset Tracking and Security," for more
information.
Enables/disables network server mode.
Specifies prompting for power-on password.
See Section 3.4, "Asset Tracking and Security," for more
information.
This selection will appear only if a power-on password is set
and the network server mode is disabled.
Enables/disables Smart Cover Sensor and Cover Lock. (Feature
supported on select models only.)
Lists most recent cover removal. (Feature supported on select
models only.)
See Section 3.4, "Asset Tracking and Security," for more
information.
Service Reference Guide