Chapter Overview; Workstation Configurations; Field Replaceable Unit (Fru) Configurations; Internal Storage Devices - HP Visualize j6000 Supplementary Manual

Configuration

Chapter Overview

Chapter Overview
This chapter contains the following main sections:
• Workstation Configurations
• Field Replaceable Unit (FRU) Configurations

— Internal Storage Devices

— Memory
— I/O Cards
Workstation Configurations
Refer to the HP Workstations web site for a complete list of supported accessories,
peripherals, and operating system versions for the J6000 workstations. The URL for the
web site is:
http://www.hp.com/visualize
Field Replaceable Unit (FRU) Configurations
This section provides information for setting up or changing the configuration of the Field
Replaceable Units (FRUs) for the J6000 workstations.
Internal Storage Devices
Hard Disk Drive Configuration
The SCSI IDs for hard disk drives are hard-wired into the SCA Ultra2 Wide LVD SCSI
interfaces in the backplane of the two disk bays within the J6000 workstations. Hence,
SCSI IDs do not need to be set for the hard disk drives installed in these workstations.
From top to bottom, the pre-set SCSI IDs for hard disk drives are: 6 and 5.
Similarly, no jumpers are installed at the factory, nor is any jumper installation required
at the customer's site, on either of the hard disk drive models that are supported with the
J6000 workstations. Both hard disk drive models may be installed as is into these
workstations.
32 Chapter 2