Resetting The Workstation - HP Visualize j6000 Supplementary Manual
Hp visualize j6000: supplementary guide
Hide thumbs
Also See for Visualize j6000:
- Administration manual (171 pages) ,
- Install manual (6 pages) ,
- Introduction (5 pages)
Table of Contents
Advertisement
Boot Console Handler
Resetting the Workstation
Resetting the Workstation
To reset the workstation to its predefined values, follow the directions in the section
"Accessing the Boot Console Handler" found in this chapter, and type the following at the
prompt to access the Configuration Menu:
Main Menu: Enter command > co [Enter]
When the Configuration Menu appears, type the following at the prompt:
Configuration Menu: Enter command > default [Enter]
Then type the following at the prompt:
Configuration Menu: Enter command > reset [Enter]
112
Chapter 5
Advertisement
Table of Contents
Troubleshooting
