HP Visualize j6000 Supplementary Manual page 21

Step 5
• Attach the new disk to the active volume group with the vgchange command.
vgchange -a y /dev/vg00
Step 6
• If the disk is not a mirror of a root disk, then skip this step.
• Run the mkboot command. For example:
mkboot /dev/rdsk/c2t5d0
• Run lvlnboot -R to relink the replaced disk into the Boot Data Reserved Area of all
the Physical volumes in the Volume group.
lvlnboot -R
Step 7
• Run the lvsync command to synchronize the physical extents of each logical volume
specified by logical volume path. Synchronization occurs only on physical extents that
are stale mirrors of the original logical extent.
lvsync /dev/<volume group name>/< LV name >
For example:
lvsync /dev/vg00/stand
lvsync /dev/vg00/swap
lvsync /dev/vg00/
At this stage, your system should be fully functioning. Use the xstm command to verify.
Chapter 1
Product Information
Front Panel Components
21