Configuring An Ide Device After Installation; Configuring A Scsi Device After Installation - HP Vectra VL600 Supplementary Manual

2 How to Install and Replace Components In Your Desktop PC
Upgrading and Installing Mass Storage Devices

Configuring an IDE Device After Installation

After installing any device, you need to view the HP Summary Screen
to verify that your PC has correctly identified the new configuration . If
the configuration is not correct, run the Setup program to configure
the device. To enter the Setup program, press
IDE drives are automatically detected by the Setup program. However,
a newly installed device may require that you install an appropriate
device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from HP's Web site at:
www.hp.com/go/vectrasupport
The IDE cables in your PC are cable select. You must, therefore, set the
jumpers on any IDE devices you install to cable select. See the
documentation for the device for more information.

Configuring a SCSI Device After Installation

To configure a SCSI drive:
1 Switch on the computer.
2 Press when the message
F6
is displayed during the PC's startup routine.
Utility...
3 Check or change the configuration of the new drive, as required.
For more information on configuring a SCSI hard drive, refer to the
SCSI Administrator's Guide available on HP's Web site at
www.hp.com/go/vectrasupport
4 When configuration is complete, exit the SCSI Configuration Utility
and reboot the computer to save any changes.
60
during startup.
F2
.
Press F6 to start Configuration