Installing An Accessory Board - HP Vectra VL600 Supplementary Manual

3 How to Install and Replace Components In Your Minitower PC
Installing Accessory Boards

Installing an Accessory Board

1 Remove the computer's cover (described in this chapter).
2 Lay the minitower on its side.
3 Remove the retaining bracket.
4 Remove the slot cover.
5 Aligning the board carefully, slide it into position and press it firmly
into the slot.
6 If you slid out the system board to allow access to a lower slot,
replace it.
7 Replace the retaining bracket.
100