Problem Installing A Lan Card; Problem Installing A Smart Card Reader; You're Having Problems Installing A Lan Card - HP Vectra VL600 Supplementary Manual

NOTE

Problem Installing a LAN Card

Problem
You have installed a LAN card but it doesn't
work.
If the LAN card still does not work
You have installed a LAN card that supports the
Wake On LAN feature and the feature does not
work.
Under Windows 95, some LAN cards may lose their LAN connection when the
PC goes into suspend mode.

Problem Installing a Smart Card Reader

Problem
You have installed a smart card reader but it
doesn't work.
1 Troubleshooting Your PC
To try and fix this...
Check that:
•
There are no IRQ conflicts with other devices.
•
The card is correctly installed in the slot.
•
There are no bent connector pins.
•
You have installed the correct drivers (refer to the board
manufacturer's web site).
•
The software installation instructions have been
followed correctly.
Try:
•
Setting the PnP Operating System field in the Setup
program to NO (applies to ISA and PCI boards). To enter
Setup, restart the PC and press F2 when the Vectra
logo appears.
•
Putting the LAN card into another PCI or ISA slot.
•
Refer to the LAN card documentation for instructions
about installing and using the LAN card.
•
Check that the Network Interface fields in the Power
menu of the Setup program are enabled. To enter Setup,
restart the PC and press F2 when the Vectra logo
appears.
To try and fix this...
Check that:
•
The device is connected to the mouse PS/2 port. This
device may not work correctly if connected to the
keyboard port,
Troubleshooting Help Zone
29