HP Vectra VL600 Supplementary Manual page 93

NOTE
NOTE
4 Slide in the new hard drive in the position shown and fasten the four
screws to secure it in position in the drive tray.
5 Slide the drive tray back into the bay.
6 Attach an IDE data connector and a power connector to each hard
disk drive.
You must use the end connector (marked DRIVE 0) with the master
hard drive. This is the drive you intend to boot your PC from.
7 Replace the cover (described in this chapter).
8 Verify the new configuration by checking the HP Summary Screen.
To access the HP Summary Screen, press
appears during startup.
If you intend to boot from the newly installed drive, ensure that you
have configured Setup to do this. Also ensure that you have installed all
the required operating system and HP drivers on the newly installed
drive. To reinstall operating system and HP drivers, use the HP Image
Creation & Recovery CD-ROM provided with the PC. In addition, you
can find the most up-to-date versions of HP drivers on HP's Web site at:
www.hp.com/go/vectrasupport.
3 How to Install and Replace Components In Your Minitower PC
Upgrading Mass Storage Devices
when the Vectra logo
Esc
93