Configuring An Ide Device After Installation - HP Compaq Evo D310 Upgrade Manual

Upgrading and replacing hardware

Configuring an IDE device after installation

After installing any device, you can check via the Summary Screen that your PC has correctly identified
the new configuration. To view the Summary screen, press F8 during startup, then select Summary from
the list of options.
If the configuration is not correct, run the Setup program to configure the device. To enter the Setup
program, press F8 during startup, then select Setup from the list of options.
IDE drives are automatically detected by the Setup program. However, a newly installed device may
required that you install an appropriate device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from the support web site.
The IDE cables in your PC are cable select. You must, therefore, set the jumpers on any IDE devices you
install to cable select. See the documentation for the device for more information.
Evo D310 Micro Desktop 17