Configuring An Ide Device After Installation - HP Vectra VL410 Upgrade Manual

5 Attach the data and power connectors and audio cable.
audio connector
(optional)
6 Replace the cover and front panel. Refer to page 10.
7 Verify the new configuration by checking the HP Summary screen. To access the HP Summary Screen,
press F8 when the HP logo appears during startup, then select the Summary option by pressing Esc.

Configuring an IDE device after installation

After installing any device, you need to view the HP Summary Screen to verify that your PC has correctly
identified the new configuration. To view the Summary screen, press F8 during startup, then select
Summary from the list of options.
If the configuration is not correct, run the Setup program to configure the device. To enter the Setup
program, press F8 during startup, then select Setup from the list of options.
IDE drives are automatically detected by the Setup program. However, a newly installed device may
required that you install an appropriate device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from HP's support web site.
The IDE cables in your PC are cable select. You must, therefore, set the jumpers on any IDE devices you
install to cable select. See the documentation for the device for more information.
Upgrading and replacing hardware
21