Setting The Safety Parameters; Figure 9: Changing Safety Parameters; Figure 10: Changed Safety Parameter - LinMot C1251-MI-XC-2S-0E Series Manual

2S Drive Systems / 0185-1174_E_1V1_SM_C1251-2S / NTI AG

7.6.1 Setting the Safety Parameters

The parameters can be set the same way as the non-safety parameters. E.g. setting the FS Config Name:

Figure 9: Changing safety parameters

Select the parameter and type in the new value, then press Enter or click on the check. And the value is changed:

Figure 10: Changed safety parameter

Note: The value is not yet stored on the drive until the validation is completely run.
0185-1174_E_1V1_SM_C1251-2S / 2021-11-26 16:43 (Rev. 12500) Page 60 of 150