Table of Contents
Advertisement
2S Drive Systems / 0185-1174_E_1V1_SM_C1251-2S / NTI AG
7.6.2.4 Print ASCII Report
The ASCII report must be printed and put together to the machine documentation. Printing can be done to a PDF file.
Click to the printing button
7.6.2.5 Validate Parameters
At the end, the parameters can be validated by clicking the button
The password must be retyped.
Figure 15: Validate Parameters
The checksum shown is calculated over the ASCII report.
The following window will finish the validation with the feedback if it was done correctly or not.
Figure 16: Status message on validation end
7.6.2.6 Safety Parameter Checksum
The safety parameter checksum shown at the end of the validation corresponds with the content of the variable
"Parameter CRC", UPID 0305h. This value must be used for validating a configuration loaded from the flash card. See
chapter 7.7 - Flash Card (FC).
0185-1174_E_1V1_SM_C1251-2S / 2021-11-26 16:43 (Rev. 12500)
.
.
Page 63 of 150
Advertisement
Table of Contents
