Setting Mode - Epever EPIPDB-COM-10 User Manual

Remote meter connection
A communication port for the remote meter
Note: where is no RTS, the controller calculate the data which got from the
local temp. sensor. The controller will come to RTS automatically when the
RTS was connected.

2.Setting mode

Three leds flashing, each LED express different specifications, choose the
LED first according to the following information, and then press the switch
for 5 seconds until the number flashing, choose one number as you need,
and leave it and the number you set will be saved.
st
1. 1 led is the battery type setting.
nd
2. 2 led is for charging priority, only set the percentage you want for
battery #1, the controller will automatically calculate the rest for battery
#2.
Number shows
1
2
3
Number
shows
0
1
Battery type
Sealed battery
Gel battery
Flooded battery
Battery #1
charging
0%
10%
2
Battery # 2
charging
100%
90%