Wall-Mounting The Chassis; Wall-Mounting The Cisco Iad2430, Cisco Iad2431, And Cisco Iad2432 Iads - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
Make sure to use the correct screws for this mounting option (see
Caution
Screws are included for attaching the brackets to the chassis, but not for installing the chassis in a rack
or on a wall. You need four additional machine screws to install the chassis in a rack. Use the screw size
required by your rack. After the brackets are secured to the chassis, you can rack-mount the chassis.
Using screws that you provide, attach the chassis to the rack as shown in
Step 2
Figure 3-8

Wall-Mounting the Chassis

The following warning applies only when the unit is wall-mounted:
This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully
Warning
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248

Wall-Mounting the Cisco IAD2430, Cisco IAD2431, and Cisco IAD2432 IADs

You can wall-mount the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD with either the right
Caution
side or the left side facing up; however, the front and back panels must be vertical.
To wall-mount the chassis, follow this procedure:
Attach the short side of one bracket to the chassis, as shown in
Step 1
hex screws (provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the
washer must fit into the bracket slot, facing the chassis.
OL-4234-06
Attaching the Chassis to the 19-Inch Rack
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide

Wall-Mounting the Chassis

Table 3-1 on page 3-7).
Figure 3-8 on page
Figure 3-9, using two 6-32 x 1/4 slotted
3-9.
3-9