Connecting The Auxiliary Port To A Modem; Cable; Procedure; Connecting The Fast Ethernet Port To The Fast Ethernet Switch - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
•

Connecting the Auxiliary Port to a Modem

To connect the auxiliary port to a modem, use the procedure in this section.

Cable

Use an RJ-45-to-DB-25 auxiliary cable (labeled Modem).

Procedure

Step 1 Connect the cable from the auxiliary port (black) to the DB-25 port on the modem. (See location 6 in
Figure 3-17 on page
Step 2 Configure the modem:
a.
b.
Note The baud rate for the auxiliary (and console) port can be configured in software for 1200, 2400, 4800,
19200, 38400, 57600, or 115200.

Connecting the Fast Ethernet Port to the Fast Ethernet Switch

To connect a Fast Ethernet port to the Fast Ethernet switch, use the procedure in this section.
Cable
Use a straight-through Fast Ethernet cable (not included).
Procedure
Connect the cable from a Fast Ethernet port to an available port on the Fast Ethernet switch. (See
Step 1
location 4 in
Connect the second cable if it is required.
Step 2
Note
OL-4234-06
no flow control
3-20.)
Match the transmission speed of the auxiliary port (default is 9600 baud).
Set the hardware flow control for Data Carrier Detect (DCD) and Data Terminal Ready (DTR)
operation.
Figure 3-17 on page
Not all models have two ports.
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-20.)
Connecting Cables
3-23