Desktop-Mounting The Chassis; Setting The Cisco Iad2435 On A Desktop; Installing The Ground Connection - Cisco IAD2430 Series Hardware Installation Manual

Desktop-Mounting the Chassis

Desktop-Mounting the Chassis
Verify that a suitable AC power outlet is available.
Step 1
Do not plug this unit into an AC outlet that does not have a UL-certified receptacle that is properly tied
Caution
into the building ground.
Place the four rubber feet (from the accessory kit) in the four indentations on the underside of the chassis.
Step 2
This helps provide proper airflow through and around the chassis.
Place the Cisco IAD on the desktop.
Step 3
Do not place anything on top of the chassis that weighs more than 10 lb (4.5 kg). Excessive weight on
Caution
top can damage the chassis.

Setting the Cisco IAD2435 on a Desktop

You can place Cisco IAD2435 on a desktop.
Do not place anything on top of the router that weighs more than 5 pounds (2.25 kg), and do not stack
Caution
routers on a desktop. Excessive distributed weight of more than 5 pounds, or pound point load of 5
pounds on top could damage the chassis.

Installing the Ground Connection

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
AC connected units must have a permanent ground connection in addition to the power cable ground
Warning
wire. NEBS-compliant grounding satisfies this requirement. Statement 284
Warning This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect
the host to earth ground during normal use. Statement 242
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-14
Chapter 3 Installing Cisco IAD2430 Series IADs
OL-4234-06