Wan And Voice Cables - Cisco IAD2430 Series Hardware Installation Manual

Connecting Cables

WAN and Voice Cables

For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection.
FXS/T3/E3 Statement 1044
The following warning also applies to Cisco IAD2430 units that have an RJ-21 interface.
Note
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
Warning
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call. Statement 1042
These cables and connections are described in
page
Table 3-4 WAN and Voice Cable Selection
Port or Interface
T1/E1 WAN
T1/E1 Digital voice
Analog voice FXS
WIC-2T Serial
WIC-1DSU-T1/E1 WAN
VIC2-4FXO FXO
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-24
3-25.
Color or Type Connected To
Light green WAN
RJ-48C Digital PBX
RJ-21 Distribution panel
Cisco 12-in-1 CSU/DSU and serial
serial port network or equipment
connector
Light green WAN
RJ-11 Station side of analog PBX
Chapter 3 Installing Cisco IAD2430 Series IADs
Table 3-4 on page 3-24 and shown in
Cable
RJ-48 T1/E1 cable (not included)
RJ-48 T1/E1 cable (not included)
RJ-21-to-RJ-21 straight-through cable
(not included)
Serial transition cable matching signaling
protocol (EIA/TIA-232, EIA/TIA-449,
V.35, X.21, or EIA-530) and operating
mode (DTE or DCE) (not included)
RJ-48 T1/E1 cable (not included)
RJ-11 cable (not included)
Figure 3-20 on
OL-4234-06