Chapter 4 Powering On Cisco Iad2430 Series Iads; Checklist For Power-On; Power-On Procedure - Cisco IAD2430 Series Hardware Installation Manual

Powering On Cisco IAD2430 Series IADs
To power on your Cisco IAD2430 series integrated access device (IAD), perform the following tasks in
the order listed, as required:
•
•
•
•

Checklist for Power-On

You can power on a Cisco IAD if it meets the requirements described in
Cisco IAD2430 Series
•
•
•

Power-On Procedure

Perform the following procedure to power on your Cisco IAD and verify that it completes its
initialization and self-test. When this is finished, the Cisco IAD is ready to configure.
To power on the Cisco IAD, follow these steps::
Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, no parity, and no
Step 1
flow control.
Move the Cisco IAD power switch to the ON position (Cisco IAD2430 through Cisco IAD2432 IADs
Step 2
only).
The green LED beside the auxiliary (AUX) port should come on, and the fan should operate.
Note
To power on the Cisco IAD2435 IAD, plug in the external power supply (see
OL-4234-06
Checklist for Power-On, page 4-1
Power-On Procedure, page 4-1
Initial Configuration Procedures, page 4-2
Troubleshooting, page 4-9
IADs":
The chassis is securely mounted.
The power cable is connected.
The interface cables are connected.
The Cisco IAD2435 IAD does not have a fan.
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
4
C H A P T E R
Chapter 3, "Installing
Figure 3-19).
4-1