Mounting The Onplus Network Agent; Placement Tips; Wall Mounting - Cisco ON100 Network Agent Quick Start Manual

Mounting the OnPlus Network Agent

3
You can place the OnPlus Network Agent on a desktop or mount it on a
wall.

Placement Tips

• Ambient Temperature—To prevent the OnPlus Network Agent from
overheating, do not operate it in an area that exceeds an ambient
temperature of 104°F (40°C).
• Air Flow—Be sure that there is adequate air flow around the unit.
When placing the OnPlus Network Agent on a desktop, make sure that the
surface is flat.

Wall Mounting

The OnPlus Network Agent does not come with a wall-mount kit. For wall
mounting, you will need:
• Two self-tapping screws, each with an outer thread diameter of
3.5 mm (0. 1 4 in) and a length of 16 mm (0.63 in).
• The outer thread diameter must not be greater than 3.7 mm (0. 1 5 in), the
head diameter must be between 6.0 mm (0.24 in) and 7.5 mm (0.29 in),
and the head height must not exceed 1.9 mm (0.07 in).
Insecure mounting can damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure
wall mounting.
To mount the OnPlus Network Agent to a wall:
• Drill two mounting holes 95 mm (3.74 in) apart horizontally.
• Attach the two self-tapping screws to the wall.
Each screw should be mounted so that the space between the wall
and the underside of the screw head is at least 5.3 mm (0.21 in).
• Slide the OnPlus Network Agent into position until the screws fit snugly
into the holes on the bottom of the unit.
Cisco ON100 Network Agent Quick Start Guide 5