Unpacking And Inspection - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
•
In addition, you might need the following external equipment:
•
•
•
•
•
•
•
•
•
Serial cables use the Cisco 12-in-1 connector on the WAN connection end.
Note

Unpacking and Inspection

Do not unpack the Cisco IAD2430 series IAD until you are ready to install it. If the installation site is
not ready, keep the chassis in its shipping container to prevent accidental damage.
The IAD, cables, and any optional equipment you ordered might be shipped in more than one container.
When you unpack each shipping container, check the packing list to ensure that you received all the
following items:
•
•
•
•
•
Note
•
OL-4234-06
Eight wood screws or other fasteners for installing the chassis on a wall. An additional starter
–
screw can be used to facilitate wall-mounting (does not include Cisco IAD2435 IAD).
– For Cisco IAD2435 IAD—two number-six, 3/4-inch (M3.5 x 20-mm) screws.
ESD-preventive wrist strap
Console terminal, or personal computer with terminal emulation software
PC running terminal emulation software for administrative access
Modem for remote access
Analog voice RJ-21 cable
Digital voice RJ-48 T1/E1 cable
Serial, RJ-48, or RJ-45 cables for connecting WAN interface cards (WICs) or voice interface cards
(VICs)
CSU/DSU for the serial interfaces
Ethernet switch
Modem for remote configuration
Cisco IAD2430 series IAD
Power cord
Power cords vary, depending upon local requirements.
Note
RJ-45-to-DB-25 adapter cable (labeled CON)
RJ-45-to-DB-9 adapter cable (labeled AUX)
Rack-mounting brackets for 19-inch rack (one pair) with screws for attaching to chassis
Rack-mount brackets for 19-inch rack, NEBS grounding kit, and chassis guard for
wall-mounting applications are not included with the Cisco IAD2435-8FXS.
Grounding lug and fasteners
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide

Unpacking and Inspection

3-5