Initial Configuration Procedures; Chapter 4 Powering On Cisco Iad2430 Serie Iad - Cisco IAD2430 Series Hardware Installation Manual

Initial Configuration Procedures

The following message appears at the end of the boot-up messages:
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
Enter no to proceed with manual configuration by using the command-line interface (CLI):
Step 3
Would you like to enter the initial configuration dialog? [yes/no]: no
Would you like to terminate autoinstall? [yes]
Press Return to terminate autoinstall and continue with manual configuration.
Step 4
Several messages appear, ending with lines similar to the following:
...
Copyright (c) 2008 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Press Return to bring up the Router> prompt:
Step 5
...
flashfs[4]: Initialization complete.
Router>
Enter privileged EXEC mode:
Step 6
Router> enable
Router#
Continue with the,
Step 7
If the
Note
the ROM monitor, see the router rebooting and ROM monitor information in the
Configuration Fundamentals Configuration Guide
Initial Configuration Procedures
This section describes how to prepare the Cisco IAD2430 IAD series IAD to perform basic
communication functions. You may initially configure your router by using the Cisco IOS
command-line interface (CLI) or by using the setup command facility. To create the initial
configuration, the setup command facility prompts you for basic information about your router and
network.
If you ordered your Cisco IAD2430 series IAD with the Simple Network-Enabled Auto-Provision
Note
(SNAP) option, no on-site configuration is required. If the Cisco IAD is connected to the WAN, the
SNAP application downloads and installs the applicable files, and configures the Cisco IAD
automatically. No additional configuration should be required. For additional information about SNAP,
see the
following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t8/ftapiad8.htm
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
4-2
"Initial Configuration Procedures" section on page
prompt appears, your system has booted in ROM monitor mode. For information on
rommon 1>
Simple Network-Enabled Auto-Provisioning for Cisco 2420 Series IADs
Chapter 4 Powering On Cisco IAD2430 Series IADs
4-2.
for your Cisco IOS software release.
Cisco IOS
feature module at the
OL-4234-06