Chapter 3
Installing Cisco IAD2430 Series IADs
Mounting Screws
Two sets of mounting screws are provided, in separate packages (Mounting screws are not included with
the Cisco IAD2435 IAD chassis). Take care to use each screw type, and washers as needed, in the
appropriate locations.
screws.
Table 3-1
Rack Mounting
•
•
Attaching the Brackets
To install the chassis in a rack with the front panel forward, attach the brackets as shown in
Figure 3-4
To install the chassis in a rack with the back panel forward, attach the brackets as shown in
Figure 3-5
To install the chassis in a center-mount telco rack, attach the brackets as shown in
OL-4234-06
Table 3-1
Rack-Mounting Screws Versus Wall-Mounting Screws
Eight countersunk Phillips head screws (four
per bracket).
Washers are not required.
19-Inch Rack Installation—Front Panel Forward
19-Inch Rack Installation—Back Panel Forward
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
clarifies the differences between rack-mounting and wall-mounting
Wall Mounting
Four 6–32 slotted hex screws (two per
•
bracket) and four plastic washers.
Washers are required.
•
Rack-Mounting the Chassis
CI SC O IA
D2 40 0
Figure
Figure
3-4.
Figure
3-5.
3-6.
3-7