Installing A Wan Or Voice Card - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
Figure 3-16
Connect the other end of the ground wire to a grounding point at your site.
Step 5

Installing a WAN or Voice Card

The Cisco IAD2430 series IADs include a slot for a WAN interface card (WIC) or a voice interface card
(VIC).
The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
Note
The following WICs and VICs (also used by the Cisco 2600 series and Cisco 3600 series routers) are
supported in releases of the Cisco IAD2430 series IADs:
•
•
•
•
•
•
•
•
•
•
•
•
•
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection.
FXS/T3/E3. Statement 1044
OL-4234-06
Chassis Ground Connection Using Ring Terminal
WIC-1T
WIC-2T
WIC-1DSU-T1/E1
VIC2-2FXS
VIC2-4FXS
VIC2-2FXO
VIC2-4FXO
VIC2-2BRI-NT/TE
WIC-1ADSL
WIC-1SHDSL-V2
WIC-1ADSL-DG
VWIC-2MFT-T1/E1
VWIC-2MFT-E1
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
Installing a WAN or Voice Card
3-17