Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual page 42

Error Messages
Error Message
The mail box is full.
Mail box nearly full.
Too many jobs for mail box.
Rewinding error.
Turn on the media take-up unit.
Media take-up unit ready.
Multi-sensor error
Cause
There is no more space on the
printer's hard disk.
The free hard disk space left for
personal boxes in the printer's
hard disk does not have 1 GB,
combined.
Saved jobs exceed the personal
box capacity.
There is some foreign object near
the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor
is soiled and the roll cannot be
detected.
The roll is out of range of detection
by the Media Take-up Unit
sensor.
The Media Take-up Unit sensor is
damaged.
A paper jam has occurred and the
roll cannot be rewound.
The Media Take-up Unit was off
when you selected Enable for
Take-up Reel .
The Take-up Reel setting in the
printer MAIN MENU was changed
from Enable to Disable , but a print
job was received before the roll
was removed.
Direct sunlight or strong lighting
may be shining on the printer and
causing the sensor to malfunction.
The performance of a sensor
inside the printer may be impaired.
Corrective Action
Press the Stop button to cancel the print job.
Delete print jobs from the queue.
(→"Managing Queued Jobs (Deleting or Preempting
Other Jobs)," User Manual)
Delete unneeded jobs stored in personal boxes (box
numbers in the range 01–29).
(→"Deleting Saved Jobs," User Manual)
Delete unneeded jobs stored in personal boxes.
(→"Deleting Saved Jobs," User Manual)
Press the Stop button to cancel the print job.
Delete print jobs from the queue.
(→"Managing Queued Jobs (Deleting or Preempting
Other Jobs)," User Manual)
Delete unneeded jobs stored in personal boxes (box
numbers in the range 01–29).
(→"Deleting Saved Jobs," User Manual)
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(→ , Loading Rolls in the Printer)
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit .
Press the Online button to clear the error.
Turn the Media Take-up Unit on.
Press the Stop button and stop printing.
The mode switches from take-up mode to regular
mode after you change the Take-up Reel setting in
the MAIN MENU from Enable to Disable and lift the
Release Lever , or after you execute Paper Cutting .
Press the Online button to resume printing.
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Turn off the printer and wait at least three seconds
before restoring the power.
If the message is displayed again, contact your Canon
dealer for assistance.
42