Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual page 31

3
Press ▲ or ▼ to select Adjust Printer , and then press
the ► button.
4
Press ▲ or ▼ to select Adjust Length , and then press
the ► button.
5
Press ▲ or ▼ to select A:High or B:Standard/Draft , and
then press the ► button.
6
Press ▲ or ▼ to select Yes , and then press the OK
button.
A test pattern is printed for adjustment based on the
amount of paper stretching or shrinkage. The scale bar
shows " Millimeter " in 50 mm units and " Inch " in 1 inch
units.
• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/
Draft .
• To cancel printing the test pattern for adjustment, hold down the Stop button for a second or more, and
then go to step 7.
7
Measure the length of the adjustment pattern. Calculate
the difference between the measured length and actual
length. Enter it as a percentage and press the OK button.
You can adjust the value in 0.02% increments. Press ▲ to
increase the value or ▼ to decrease it.
If the scale is printed shorter than actual size, set the
value toward the positive side; if it is printed longer, set the
value toward the negative side.
• You can also specify the adjustment value in Adjust Length in the Paper Details menu. In this case,
no test pattern for adjustment is printed.
31
If Line Length Does Not Match
Millimeter Inch