Starting Projection - Canon REALiS WUX4000 User Manual

Starting Projection

1
Check the connection between the projector and the computer or AV equipment.
(P42 – P44)
2
Connect the power cord and make sure that the [STAND BY] indicator is lit (red).
•
Fully insert the power cord plug into the socket.
•
After turning off the projector, wait at least 5 minutes before turning it on again.
It may shorten the lamp life if you turn on the projector immediately after turning
it off.
•
Unplug the power cord when not in use.
3
Press the POWER button.
The [POWER] indicator flashes green, and then stops flashing and remains lit.
The countdown window is displayed for approximately 20 seconds, and then the pro-
jection is started. Press the OK button to make the countdown window disappear.
4
Turn on the computer or AV equipment power.
Connect the ground terminal on the power plug to ground. Not
doing so could result in an electric shock. Also the computer
may suffer electromagnetic interference or be subject to poor TV
and radio reception.
Remote control Projector
45