Table of Contents
Advertisement
Chapter 2: Installing the Wireless Access Point
Connecting the AC Power Adapter
52
The access point can be powered with PoE+ on the LAN1 or/and LAN2
ports, an AC power adapter, or both. A wireless access point that is
powered by both methods uses the AC adapter as its primary power and
PoE as redundant power. For an AC power adapter, Allied Telesis
recommends the PWRADP-01 (DA-48Z12) Power Adapter.
If you purchased a power adapter for the wireless access point, perform
the following procedure. Otherwise, go to "Attaching the Access Point to
the Mounting Bracket" on page 53.
Perform the following procedure to install an AC power adapter:
1. If the AC power adapter has replaceable AC plugs, verify that the
current plug on the adapter is the correct plug for your region. If it is
not, install the correct AC plug by following the instructions provided
with the adapter.
2. Plug the DC connector of the power adapter into the DC IN jack on
the access point. Refer to Figure 24.
Figure 24. Connecting an AC Power Adapter to the Access Point
3. Connect the power adapter into an appropriate AC power source.
4. Turn on the Power Switch.
Note
The Power Switch controls power from the AC power supply. It
does not control PoE+ on the LAN1 and LAN2 ports.
5. Go to "Attaching the Access Point to the Mounting Bracket" on
page 53.
Advertisement
Table of Contents
