Sd Card Format - Racelogic Performance Box Touch V2 Quick Start Manual

Reset
Pressing the Reset button at the bottom right of the screen will reset all test results shown on the current screen.
When you press it, the LEDs will briefly flash
Logging
Performance Box Touch logs data via an SD card inserted into the SD Card Slot on the left-hand side of the unit.
Depending on the Logging Strategy you have selected in the
or only when it detects movement.
You can manually override the configured logging strategy by tapping on the SD Card Icon when it is
green to start or stop the logging.
The Record Icon will show when the unit is logging data to the SD card.
If you have come to a stop, but the Record Icon is still on, you must press the SD Card Icon to stop
the logging before you remove the SD card.
Sometimes, due to poor satellite visibility, for example in a garage or close to a building, Performance Box
Touch may start recording even if the car is stationary. Always check the Record Icon to make sure the
unit is not recording before you eject the SD card.
IMPORTANT
The SD card should not be removed when the Record Icon flashes red as it may cause you to lose
data.
Note: If the SD card is removed while the box is still recording, you may need to repair it on a PC before
you can use it again.

SD Card Format

Performance Box Touch V2 is supplied with an 8 GB SDHC card in a FAT32 file format, which is the only file format
it supports.
green twice and the unit will emit an audible confirmation notification.
General Settings, the unit will either log continuously
21