Racelogic Performance Box Touch V2 Quick Start Manual page 18

Note: This setting will only apply to the Primary Test.
One-foot Rollout
When enabled, the test will not commence until the vehicle has travelled a distance of 1 ft or 0.305 m. You can find
more information on the one-foot rollout feature here.
Notes:
• You cannot enable One-foot Rollout while Slope Correct is enabled.
• When One-foot Rollout is enabled, 1ft will appear next to the Test heading on the Primary Acceleration
Display Screen and ONE FOOT ROLLOUT will be displayed on the right-hand side of the new session header
in the Test Results.
Slope Correct
When you enable the Slope Correct, the Performance Box Touch will apply a DB Scanner slope correction method to
the 'speed to speed' or 'speed to distance' acceleration test results that are presented on the screen.
Notes:
• Slope correction only applies to the live display results to match post-process corrections from the DB
Scanner third-party software. You cannot apply post-process corrections with Racelogic software programs.
• You cannot enable Slope Correct while One-Foot Rollout is enabled.
• If you have enabled Slope Correct, DBSC will appear next to the Test heading on the Primary Acceleration
Display Screen and DBSCANNER SLOPE CORRECTED will be displayed on the right-hand side of the new
session header in the Test Results.
18