Table of Contents
Advertisement
Figure 30. Installing a 2.5 inch drive into a 3.5 inch drive adapter
Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
Prerequisites
1
Follow the safety guidelines listed in
2
If installed, remove the front bezel.
3
Remove the 3.5 inch drive carrier from the system.
Steps
1
Using the Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
2
Lift the 3.5 inch drive adapter out of the 3.5 inch drive carrier.
78
Installation and Service Manual
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
