Figure 36. Installing a drive into the drive carrier
Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
remove the front bezel.
3.
Remove the drive
carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
2. Lift the 3.5 inch drive adapter out of the 3.5 inch drive carrier.
Figure 37. Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
78
Installing and removing system components
Safety instructions
on page 66.