Table of Contents
Advertisement
4 .
O P E R A T I N G T H E P R O J E C T O R
4.1.
G
E N E R A L
Before operating the projector, verify that all phases of installation and assembly have been
completed.
• Verify that cover for belt side of projector is installed before and
• Do not make adjustments on belt side of projector while cover is
• Do not make adjustments or perform maintenance on projector
WARNING
4.2.
P
-O
R E
P E R A T I N G
4 . 2 . 1 .
F
L Y W H E E L
1. Back out flywheel set screw far enough to let flywheel slide onto shaft without scoring
shaft or damaging threads on set screw.
2. Slide flywheel onto shaft until it stops.
3. Position set screw over flat portion of shaft and tighten set screw.
4. Spin flywheel by hand to check for smooth operation.
CHRISTIE
this time.
4 . 2 . 2 .
T
U R R E T
1. Secure turret hinge plate with four Allen head screws.
2. Install turret latch assembly using same holes and hardware (if it is not already installed).
3. Connect turret wiring to TB4-1 (Red) and TB4-2 (Black).
CHRISTIE DIGITAL SYSTEMS P35GPS Projector
March, 2004
4-1
during operation.
removed or power is on.
while it is in operation.
P
R O C E D U R E S
I
N S T A L L A T I O N
recommends that any projector accessories be installed at
I
N S T A L L A T I O N
4
Advertisement
Table of Contents
