Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
4.3.2
Shaft-Hub Clamping
4.4 Material Data
Component
Linear Rotary Shaft
Front Flange
Linear Ball Bearing
Wiper
Housing Linear Rotary Motor
Page 12 / 39
The shaft-hub clamping is a non-positive
connection which is produced by means of two
conical rings.
The use of drivers or the production of grooves is
completely eliminated. The suitable shaft-hub
clamping type can be ordered from LinMot.
Mounting instructions and ordering information can
be found in the "Accessories" chapter.
Material
Quenched and tempered steel 1.0601 / C60
Hard anodized aluminium 3.3206
Steel
NBR
Hard anodized aluminium 3.3206
PR02-38
ENG
NTI AG / LinMot
Advertisement
Table of Contents
